Installation 2.0
KEY LINKS
INSTALLATION OVERVIEW
01
Read the Pre-Installation Checklist
02
WARNING
Do not attempt to install SkyBell in wet conditions. Do not proceed if you, SkyBell or the area around your door is
wet. SkyBell can only be attached to a low voltage transformer (12-36 VAC) and not directly to the primary power
(110/120 VAC and 220/230/240 VAC). If you do not use a doorbell chime, you MUST use a 10 ohm/10 watt resistor between SkyBell and one wire from the power source. Resistor not included in the packaging.
03
Remove the current doorbell.
04
Screw baseplate into wall
05
Attach each SkyBell wire to a home doorbell wire with the blue connectors. If no doorbell chime, you must use a resistor. See power diagrams for more info.
06
Place device on the mounting plate, make sure the device
is flush to wall.
07
Insert locking tool in a small hole at bottom of the device. Turn 3 whole rotations to the left to secure the device in place. See video!